Advertisement
Button
1
Press the button on the trigger.
2
Turn the switching lever in the direction of the arrow.
3
Set the switching lever as above picture.
Switching lever
Switching lever
CONTACT TRIP
The common operating procedure on "Contact Trip" tools is for
the operator to contact the work to actuate the trip mechanism
while keeping the trigger pulled, thus driving a fastener each
time the work is contacted.
All pneumatic tools are subject to recoil when driving fasteners.
The tool may bounce, releasing the trip, and if unintentionally
allowed to recontact the work surface with the trigger still actu-
ated (finger still holding trigger pulled) an unwanted second
fastener will be driven.
DRIVING DEPTH ADJUSTIMENT DIAL
Adjustment dial
WARNING
ALWAYS-disconnect air supply before adjusting adjustment
dial.
1
If a Adjustment is required, disconnect air supply.
2
Refer to the figure for direction to turn the dial.
3
Reconnect air supply.
8
Trigger
Contact arm
Advertisement
