Advertisement
12. USE SPECIFIED FASTENERS (SEE PAGE 5)
The use of fasteners other than specified fasteners will
cause the tool malfunction. Be sure to use only specified
fasteners when operating the tool.
13. PLACE THE DISCHARGE OUTLET ON THE WORK
SURFACE PROPERLY
Failure to place the discharge outlet of the nose in a proper
manner can result in a fastener flying up and is extremely
dangerous.
14. KEEP HANDS AND BODY AWAY FROM THE DIS-
CHARGE OUTLET
When loading and using the tool, never place a hand or
any part of body in fastener discharge area of the tool. It is
very dangerous to hit the hands or body by mistake.
15. DO NOT DRIVE FASTENERS CLOSE TO THE EDGE
AND CORNER OF THE WORK AND THIN MATERIAL
The workpiece is likely to split and the fastener could fly
free and hit someone.
16. DO NOT DRIVE FASTENERS ON TOP OF OTHER
FASTENERS
Driving fasteners on the top of other fasteners may cause
deflection fasteners which could cause injury.
17. REMOVING THE FASTENERS AFTER COMPLETING
OPERATION
If fasteners are left in the magazine after the completion of
operation, there is the danger of a serious accident occur-
ring prior to the resumption of operation, should the tool be
handled carelessly, or when connecting the air fitting. For
this reason, always remove all fasteners remaining in the
magazine after completion of the operation.
18. CHECK OPERATION OF THE CONTACT TRIP MECHA-
NISM FREQUENTLY INCASE OF USING A CONTACT
TRIP TYPETOOL
Do not use the tool if the trip is not working correctly as
accidental driving of a fastener may result. Do not interfere
with the proper operation of the contact trip mechanism.
19. WHEN USING THE TOOL OUTSIDE OR ELEVATED
PLACE
When fastening roofs or similar slanted surface, start fas-
tening at the lower part and gradually work your way up.
Fastening backward is dangerous as you may lose your
foot place.
Secure the hose at a point close to the area you are going
to drive fasteners. Accidents may be caused due to the
hose being pulled inadvertently or getting caught.
20. NEVER USE THE TOOL IF ANY PORTION OF THE
TOOL CONTROLS (e.g., TRIGGER, CONTACT ARM) IS
INOPERABLE, DISCONNECTED, ALTERED OR NOT
WOKING PROPERLY
21. NEVER ACTUATE THE TOOL INTO FREE SPACE
This will avoid any hazard caused by free flying fasteners
and excessive strain of the tool.
22. ALWAYS ASSUME THAT THE TOOL CONTAINS FAS-
TENERS
23. RESPECT THE TOOL AS A WORKING IMPLEMENT
24. NO HORSEPLAY
25. NEVER LOAD THE TOOL WITH FASTENERS WHEN
ANY ONE OF THE OPERATING CONTROLS (e.g.,
TRIGGER, CONTACT ARM) IS ACTIVATED
26. WHEN DISPOSING THE MACHINE OR ITS PARTS,
FOLLOW THE RELEVANT NATIONAL RULES
OBSERVE THE FOLLOWING GENERAL CAU-
TION IN ADDITION TO THE OTHER WARNINGS
CONTAINED IN THIS MANUAL
Do not use the tool as a hammer.
Always carry the tool by the grip, never carry the tool by
the air hose.
The tool must be used only for the purpose it was de-
signed.
Never remove, tamper with the operating controls (e.g.,
TRIGGER, CONTACT ARM)
Keep the tool in a dry place out of reach of children when
not in use.
Do not use the tool without Safety Warning label.
Do not modify the tool from original design or function
without approval by MAX CO., LTD.
4
Advertisement
