Setting Of Interruption Table; 2.2.1 Setting Of Signals - YASKAWA YRC1000 Instructions Manual

2.2

2.2.1 Setting of Signals

2 Setting of the Interrupt Job Function
2.2

Setting of Interruption Table

Setting of Interruption Table
In a system where an independent control is used simultaneously with the
interrupt job function, an interrupt job can be set and executed for each
task.
When using four tasks (16 tasks maximum) for the independent control:
Pressing the [PAGE] changes the table No. in this order : "1" → "2" → "3"
→ "4" → "1."
Pressing [SHIFT] + [PAGE] changes the table No. in the reverse order :
"4" → "3" → "2" → "1" → "4."
1. Move the cursor to the item to be selected, and press [SELECT].
2. Enter a numerical value using the Numeric keys.
Entering "0" in SIGNAL clears the set signal No. and job
NOTE
name.
2-3
HW1483372
HW1483372
12/27