YASKAWA YRC1000 Instructions Manual page 5

HW1483372
Definition of Terms Used Often in This Manual
• Perform the following inspection procedures prior to conducting
manipulator teaching. If there is any problem, immediately take
necessary steps to solve it, such as maintenance and repair.
– Check for a problem in manipulator movement.
– Check for damage to insulation and sheathing of external wires.
• Always return the programming pendant to the hook on the
YRC1000 cabinet after use.
If the programming pendant is left unattended on the manipulator, on a
fixture, or on the floor, etc., the Enable Switch may be activated due to
surface irregularities of where it is left, and the servo power may be
turned ON. In addition, in case the operation of the manipulator starts,
the manipulator or the tool may hit the programming pendant left
unattended, which may result in personal injury and/or equipment
damage.
The MOTOMAN is the YASKAWA industrial robot product.
The MOTOMAN usually consists of the manipulator, the controller, the
programming pendant, and manipulator cables.
In this manual, the equipment is designated as follows:
Equipment
YRC1000 Controller
YRC1000 Programming Pendant
Cable between the manipulator and the
controller
v
WARNING
Manual Designation
YRC1000
Programming Pendant
Manipulator Cable
HW1483372
5/27