Inch Display - Subaru Legacy 2015 Technicians Reference Booklet

2015 Legacy and Outback

7.0 Inch Display

1. With the main power OFF, press the button (b) twice while pressing the button (a)
simultaneously.
Note: Pressing the button (c) for 3 seconds or more, or turning the ignition from ACC OFF
to ON position can exit the diagnostic mode.
2. << Line Diag>> screen is displayed.
3. Check the connection status for each item listed in {Connectivity Check} displayed on
the left of the screen.
This Line Check function allows the displayed signals to be checked for connection to the
Infotainment system. Activate each device to create the input signal needed to change the detection
status from NG to OK.
The Camera Setting allows adjustment of the displayed guide lines that appear when the vehicle
is in reverse gear range. Audio check rotates the sound from the radio to each speaker. Turn up
the volume to monitor each speaker.
Note: GPS will indicate NG on non-Navigation equipped Infotainment systems.
Note: The vehicle signal check does not change to "OFF" after a signal has been
received (ON) and then removed, until the ignition is cycled.
(c)
Activating Line Check
Line Diag
Connectivity Check
GPS OK UART
MIC OK CAN
Rr_CAM OK
AUX OK
USB1 OK
USB2 OK
Camera Setting Audio Check
Line Diagnostic Information
23
New Technology Training
(b)
(a)
1-49
Vehicle Signal Check
+
OK
OFF
ILL
OK
SPD OFF
OK
PKB ON
REV
OFF
IGN OFF
1-50
(Module 926)
June 2014