Ssm Procedure - Subaru Legacy 2015 Technicians Reference Booklet

2015 Legacy and Outback

SSM Procedure

Note: Turn the Ignition switch to the ON position. Wait for 10 Seconds
Incorrect preparation of the Radar Axis Alignment will generate the following message:
Note: "Quantity of Object Reflection (dB)" is a value to express radar signal strength
and is used for research purposes only. This information is not provided for
technician diagnostics.
New Technology Training
SSMII Work Support
Radar Axis Alignment
[axis adjustment result]
Radar Alignment Successful
Angle Gap-3.0
Quantity Object Reflection 46dB
Please push OK
Radar Alignment Unsuccessful
Radar unit angled toward front
Please check Radar Reflector
preparation, Radar bracket, and
Radar bracket installation to the
vehicle body.
Radar Alignment Unsuccessful
Radar unit angled toward rear
Please check Radar Reflector
preparation, Radar bracket, and
Radar bracket installation to the
vehicle body.
Radar Alignment SSMIII Messages
123
7-46
Please turn IGN_OFF
Radar Adjustment Unsuccessful
Please turn IGN_OFF
Perform Radar Axis Alignment again
(Module 926)
7-45
7-47
June 2014