Subaru Legacy 2015 Technicians Reference Booklet page 27

2015 Legacy and Outback
New Technology Training
(Module 926)
Move the clip up and down to clear the locking tabs from the body (mounting area).
1-61 1-62
Removing Clips Clip and Hook Tool
The clip can be re-used if not deformed. Install both clips into Assist Grip. The clips must be flush
on the inboard side.
1-63
1-64
Clip and Assist Grip Clip Installed
Install and fully seat the cap on both ends of the Assist Grip. The front and rear Assist Grips are
different. Be certain to install to the correct location.
1-65 1-66
Installing Cap Assist Grip Ready for Installation
Align the Assist Grip over the body and firmly press inward. Test the installation by pulling on the
Assist Grip.
June 2014
27