Directions For Use - Sanremo Milano SAP Instruction Booklet

Hide thumbs

Table of Contents

ENGLISH

The appliance must not be cleaned using a water jet.

Do not put the appliance in water.

The appliance must not be positioned near to any source of heat.

The appliance is unsuitable for outdoor installation.

To ensure safe use the appliance must be in a level position.

If the power cable is damaged, have it replaced by a SANREMO After-Sales Service

Centre, since a special tool is required for this purpose.

The appliance must be used in rooms with a temperature between 5°C and 35°C.

IN THE EVENT OF FAILURE OR MALFUNCTION, REQUEST SERVICE ONLY FROM QUALIFIED

PERSONNEL AT THE AFTER-SALES SERVICE CENTRE.

The data and features indicated in this booklet are not binding on the manufacturer, which reserves the

right to make changes to its models at any time.

The manufacturer shall not be under any liability for injury to persons or damage to property arising from

failure to comply with the instructions given in this booklet.

a) To access this phase keep the button M5 on the first pushbutton panel on the left pressed for over 5

seconds. The indicator lights of the buttons M5 start to blink continuously. Select the caption corresponding

to the amount required and press to dispense. The indicator light of button M5 and that of the selected

caption remain lit. When the required amount has been dispensed, press the selected dispensing button

again so that the control unit stores the data. Repeat the above procedure for all 4 dispensing buttons on

the pushbutton panel. A dispensed quantity may also be set for the hot water button (M6) by repeating

the above procedure. Upon completion of the procedure, the remaining groups will automatically use

the stored quantity. The other groups may, however, be programmed independently by repeating the

same procedure as above after having programmed the first group on the left.

b) There are 2 safety systems inside the control unit designed to protect the electronic system and the

various parts of the appliance. If, upon pressing a dispensing button, the corresponding indicator

light starts blinking, this indicates a malfunction in the electronic system or lack of water. For safety

reasons, the dispensing of water stops after 4 minutes and in any case after 4 litres of water.

c) The MILANO SED electronics also offers the possibility of reproducing the pre-brewing effect by

wetting the coffee for 0.6 seconds and then stopping the subsequent brewing from starting for 1.2

seconds. This option is only applicable for single shots of coffee.

With the appliance switched off, put the on/off switch (D) to position 1 and at the same time keep the

button (M1) on the left-hand group pressed until the indicator light corresponding to the button (M5)

remains lit; then release the button (M1). Now put the on/off switch (D) to position 0 and then to position

2 in order to store the operation.

With the appliance switched off, put the on/off switch (D) to position 1 and at the same time keep the

button (M2) on the left-hand group pressed until the indicator light corresponding to the button (M5)

remains lit; then release the button (M2). Now switch the appliance off and then on again using the on/off

switch (D) in order to store the operation.

WARNINGS