Directions For Use - Sanremo Amalfi 2GR SED Instruction Booklet

Hide thumbs

Table of Contents

Available languages

ENGLISH

The volumetric dispensing by microprocessor is a technologically highly sophisticated system that allows

many programmable functions and extreme reliability to be obtained while keeping dimensions to a

minimum.

A single control unit controls both the water level in the boiler and the various coffee quantities. The

electronic system comprises:

- power pack with high insulation transformer resistant to short circuit in compliance with the standards

UL940VO, VDE 0551 and EEC 15;

- boiler water level control through maximum level sensor;

- data transmission;

- programmable pushbutton panel with four coffee quantities, a button for programming or continual

dispensing and a programmable button for the dispensing of hot water;

- relays in compliance with the standard VDE 0551, UL940VO and with 4kW insulation;

- printed circuits in FR4 to UL940VO.

a) To access this phase keep the button M5 on the ﬁ rst pushbutton panel on the left pressed for over 5

seconds. The indicator lights of the buttons M5 start to blink continuously. Select the caption corresponding

to the amount required and press to dispense. The indicator light of button M5 and that of the selected

caption remain lit. When the required amount has been dispensed, press the selected dispensing button

again so that the control unit stores the data. Repeat the above procedure for all 4 dispensing buttons on

the pushbutton panel. A dispensed quantity may also be set for the hot water button (M6) by repeating

the above procedure. Upon completion of the procedure, the remaining groups will automatically use

the stored quantity. The other groups may, however, be programmed independently by repeating the

same procedure as above after having programmed the ﬁ rst group on the left.

b) There are 2 safety systems inside the control unit designed to protect the electronic system and the

various parts of the appliance. If, upon pressing a dispensing button, the corresponding indicator

light starts blinking, this indicates a malfunction in the electronic system or lack of water. For safety

reasons, the dispensing of water stops after 4 minutes and in any case after 4 litres of water.

c) The AMALFI SED electronics also offers the possibility of reproducing the pre-brewing effect by wetting

the coffee for 0.6 seconds and then stopping the subsequent brewing from starting for 1.2 seconds.

This option is only applicable for single shots of coffee.

With the appliance switched off, put the on/off switch (D) to position 1 and at the same time keep the

button (M1) on the left-hand group pressed until the indicator light corresponding to the button (M5)

remains lit; then release the button (M1). Now put the on/off switch (D) to position 0 and then to position

2 in order to store the operation.

With the appliance switched off, put the on/off switch (D) to position 1 and at the same time keep the

button (M2) on the left-hand group pressed until the indicator light corresponding to the button (M5)

remains lit; then release the button (M2). Now switch the appliance off and then on again using the on/off

switch (D) in order to store the operation.

MICROPROCESSOR DISPENSING