Warranty - Sanremo Milano SAP Instruction Booklet

ENGLISH
Coffee with Mod. MILANO SAP
Insert the filter holder (E) into the group head (F) turning the filter holder counter-clockwise. Press button
(I), wait for the required quantity of coffee to be dispensed and then put it back to its original position.
Coffee with Mod. MILANO SED
Insert the filter holder (E) into the group head (F) turning the filter holder counter-clockwise. Select the type
of dispensing required on the keypad (M):
M1=One strong/normal coffee.
M2=One normal/weak coffee.
M3=Two strong/normal coffees.
M4=Two normal/weak coffees.
M5=Electronic programming key or continuous manual dispensing.
CLEANING
Filter: after having dispensed the last cup of coffee, the filter and filter holder must be washed with
water. If they are damaged, worn or clogged, they should be replaced.
Drip tray and grid: the drip tray and grid should be removed frequently and coffee residues cleaned away.
Water softener: the softener should be periodically regenerated according to the manufacturer's
directions given in the instruction booklet.
External housing: the external housing and the steel parts should be cleaned with sponges and soft
cloths to avoid scratching. Only use detergents that do not contain abrasive powders or solvents and do
not use steel wool.
WARNINGS: when using the appliance it is recommended that the various instruments be kept under
control, checking that they are in the previously indicated normal working conditions.
APPLIANCE FAILURE
The user must check that this is not due to:
- power failure or blackout.
- lack of mains water supply or no water inside the boiler.
For any other causes, contact a qualified SANREMO After-Sales Service Centre.
BEFORE CARRYING OUT ANY WORK INSIDE THE APPLIANCE OR REMOVING ANY PART
OF THE HOUSING, ALWAYS DISCONNECT FROM THE ELECTRICITY SUPPLY.

WARRANTY

Each appliance purchased (keep the tax receipt, invoice and delivery note) is covered by the statutory
guarantee. This covers the free replacement of parts with manufacturing defects, following confirmation
of the defect by the service centre or manufacturer and providing the appliance has not been used
improperly or tampered with by unauthorised persons or using incorrect components or techniques.
The faulty part must be returned to the manufacturer.
NB: Never operate the pump dry (without water) as this would lead to overheating and damage. In
the event of damage caused by failure to observe this warning, the pump will not be replaced under
guarantee.
If the pump is used improperly, it will not be replaced under guarantee.
28