Warranty - Sanremo TORINO SAP Instruction Booklet

ENGLISH
M5=Electronic settings button or continuous manual delivery.
that the control unit stores the data. Repeat the above procedure for all 4 dispensing buttons on the pushbutton panel. A dispensed quantity
TORINO SED
c) The electronics also offers the possibility of reproducing the pre-brewing effect by wetting the coffee for 0.6 seconds and then
stopping the subsequent brewing from starting for 1.2 seconds. This option is only applicable for single shots of coffee.
Drip tray and grid
:
the drip tray and grid should be removed frequently and coffee residues cleaned away.
Water softener:
External housing:
the external housing and the steel parts should be cleaned with sponges and soft cloths to avoid scratching. Only use
detergents that do not contain abrasive powders or solvents and do not use steel wool.
WARNINGS:
BEFORE CARRYING OUT ANY WORK INSIDE THE APPLIANCE OR REMOVING ANY PART OF THE HOUSING, ALWAYS DISCONNECT FROM THE
ELECTRICITY SUPPLY.
and providing that the appliance has not been misused or tampered with by unauthorised persons or persons using incorrect components or
techniques.
Any defective part shall be returned to the manufacturer.
NOTE: never activate the pump without water. Excessive heat will damage the pump and
The appliance must not be cleaned using a water jet.
Do not put the appliance in water.
The appliance must not be positioned near to any source of heat.
The appliance is unsuitable for outdoor installation.
Children must be supervised to make sure they do not play with the appliance.
Access to the service area is limited to persons with knowledge and practical experience of the appliance, particularly as regards safety and
hygiene aspects.
COFFEE DELIVERY TORINO SED MODEL
DISPENSER PROGRAMMING
CLEANING
APPLIANCE FAILURE

WARRANTY

WARNINGS
28
no warranty replacement is granted in that case.