Xgig1000 Chassis Shutdown Sequence; Shutdown Using The Web Utility Interface; Shutdown Using The Console Interface - Viavi Xgig1000 Hardware Manual

Xgig1000 Chassis Shutdown Sequence

The following are the proper shutdown sequences for the Xgig1000 chassis.
NOTE
The LED behavior at shutdown is different between the two generations of the Xgig1000
chassis (see
• When the first generation chassis is shutdown, the left management port LED goes
out, while the "right" management port LED stays lit yellow, and the System LED
changes from green to yellow.
• When the second generation chassis is shutdown, all LEDs and power will be
turned off.
You must follow one of these procedures before removing power from the chassis.
WARNING
Serious errors may occur if the Xgig1000 chassis is not shutdown properly. You must
follow one of the procedures below before removing power from the chassis.
If you experience problems with restarting the chassis after powering down and then reap-
plying power to the unit, see "Power up problems following chassis shutdown" on page 130
in the Troubleshooting section.

Shutdown Using the Web Utility Interface

1 Determine the IP address of the unit.
2 From the Internet Explorer application, connect to the unit.
3 From the Server drag down menu, select Shutdown.
4 Wait until the chassis shuts down completely before removing power. When the unit
has completely shutdown, the behavior of the LEDs varies based on the generation
of the chassis (see the note above.)

Shutdown Using the Console Interface

1 Ensure that the direct communication with the unit is achieved by:
a
b
c
2 Type in "S" to initiate system shutdown.
March 2017
"Xgig1000 Systems" on page
Connect a null modem cable to the console port of the Xgig1000 chassis.
Open the console interface by using HyperTerminal or an equivalent interface.
Press Enter and verify that the unit information refreshes.
Xgig1000 Hardware Guide
Chapter 2 Xgig1000 System Setup
Xgig1000 Chassis Shutdown Sequence
2).
Page 99