Table of Contents
Advertisement
1.2 Software Installation
The software version for this AlphaLine instrument is 1.X.
1.2.1 Selecting Active Software
The AlphaLine instrument is stocked in the warehouse with all software pre-installed. The commissioning engineer will
select the function the AlphaLine instrument requires.
When a AlphaLine instrument is started up for the first time, or after a RESET, a selection menu appears where the
required application can be selected. See Figure 12: First Start up Screen (Empty) on page 20.
Figure 12: First Start up Screen (Empty)
1. Search for the required application by touching the < or > buttons.
2. Touch the Start application button once the required application appears in the window.
The AlphaLine instrument will restart and install the selected application. This will take a couple of minutes to
complete. Please be patient.
Note DO NOT switch off or disconnect the AlphaLine instrument while installing – this will corrupt the
software and make the AlphaLine instrument inoperable.
Note When the installation has been completed, the main screen of the application will appear.
1.2.1.1 Software Applications
The selection menu shows the whole range of AlphaLine instruments applicable to this screen format and orientation,
with the name of the software application displayed in the window. This name is different from the commercial name of
the instrument. Below, you will find the correct software application name for the AlphaTurn.
Software Application Name
ROT_MED_6,5_PT_SEA
Table 8: MFM Software Applications
20 | Installation Instructions
Commercial Name Instrument
AlphaTurn
Advertisement
Table of Contents
