Unfastening The Harness; Removing The Restraints; Figure 28 - Patient Secured; Figure 29 - Removing The Harness - Ferno 50-E User Manual

Ferno Model 50-E
6. Fasten the two one-piece restraints across the
patient's chest (but under the arms) and thighs
(Figure 28).
7. Make sure the buckles are securely fastened and
make further adjustments to the three restraints
to assure they safely secure the patient without
causing discomfort or impairing circulation.

6.7 Unfastening the Harness

The harness is designed for quick removal to make
patient transfers easier. If the bedding will be used to
transfer the patient, remove the shoulder harness but
leave the other straps attached to the stretcher top.
To remove the shoulder harness with the patient on the
stretcher top:
1. Unfasten all three restraints and place the ends
out of the way.
2. Pull the shoulder straps over the patient's head
and place them clear of the patient.
3. Remove the retaining plug from the harness by
pulling on the tag attached to the plug. Unhook
the bracket from the post and remove.
4. Pull the harness straps toward the head end and
carefully slide the straps from under the patient.
Follow your local protocols (Figure 29).
5. Transfer the patient following approved EMS
procedures and your local protocols.

6.8 Removing the Restraints

To remove the harness completely for cleaning:
1. Follow the instructions in Unfastening the
Harness above.
2. Unhook the pelvis strap brackets from the posts.
3. Remove the one-piece restraints by unthreading
the restraints from the backrest and leg section.
© Ferno-Washington, Inc. 234-3257-01 December, 2004

Figure 28 - Patient Secured

Figure 29 - Removing the Harness

Setup
23