Replace Hydraulic Tank Return Filter Element; Replace The Cab Air Intake Filter Element (If Equipped) - Genie GTH-636 Maintenance Manual

September 2016
A-5 A-5 R eplac e Hy draulic T ank R eturn Filter Elem ent
Replace Hydraulic Tank Return
Filter Element
Genie specifications require that this procedure be
performed annually.
Perform this procedure more often if dusty
conditions exist.
Replacement of the hydraulic filters is essential for
good machine performance and service life. A dirty
or clogged filter may cause the machine to perform
poorly and continued use may cause component
damage. Extremely dirty conditions may require
that the filter be replaced more often.
Bodily injury hazard. Beware of
hot oil. Contact with hot oil may
cause severe burns.
Note: Perform this procedure with the engine off.
1 Locate the hydraulic tank return filter.
Note: Location and access may vary, depending on
model.
2 Release the pressure in the oil reservoir by
loosening the filler/breather cap.
3 Unscrew the return filter.
4 Install the new filter element.
5 Tighten the filler/breather cap.
6 Record the hours the filter element was
replaced and keep with your maintenance
records.
7 Start the engine.
8 Inspect the filter assembly to be sure that
there are no leaks.
9 Clean up any oil that may have spilled during
the installation procedure.
Part No. 1272858
Annual Maintenance Procedures
A-6 A-6 R eplac e the C ab Air Intak e Filter Elem ent (if equi pped)
Replace the Cab Air Intake Filter
Element (if equipped)
Genie specifications require that this procedure be
performed annually.
Perform this procedure more often if dusty
conditions exist.
Note: Location of the air intake access cover will
vary, depending on specific models.
1 Remove the fasteners securing the cab air
intake access cover and remove the cover.
2 Remove the air intake filter element.
3 Install the new filter element.
4 Re-install the cab air intake access cover.
Genie Telehandlers
Maintenance Manual
41