Genie GTH-636 Maintenance Manual page 40

Maintenance Manual
Quarterly Maintenance Procedures
3 Repeat the procedure for the lower wear pads.
4 Measure each side wear pad.
Result: The measurement is within
specification.
Result: The measurement is less than
specification. Replace all side wear pads.
Refer to the appropriate Service and Repair
Manual for repair procedure,
the Boom Wear Pads.
Boom Wear Pad Specifications
Side wear pad thickness, minimum
30
GTH-1256, GTH-1544 and GTH-5519
1
2
How to Replace
Result: if thickness is less than 0.04 inches / 1 mm,
replace the worn pad. Refer to the appropriate
Service and Repair Manual for repair procedure,
3/8 inch
How to Replace the Boom Wear Pads
9.5 mm
Boom Wear Pad Screws Tightening Specifications
Screws M10
Genie Telehandlers
Extend the boom until the wear pads are
accessible.
Inspect each pad and ensure that the pad
thickness is more than 0.04 inches / 1 mm
(see figure).
Result: If thickness is above 0.04 inches /
1 mm, the pad can be re-used.
1 Maximum wearing thickness
2 Minimum wearing thickness
September 2016
.
22 ft-lbs
30 Nm
Part No. 1272858