Step 9: Installation Review
Now review the hardware installation process, assuring that:
All connectors are properly connected.
Each SCSI device has its own unique SCSI ID number.
The last physical SCSI device on the bus is properly terminated.
Notes
Red edge of 50 pin flat SCSI cable must be on pin 1 of host adapter.
The following is a sample configuration of CDU948S installation.
Audio Cable
(supplied)
Sound Card
(Not included)
Speakers
(Not included)
Step 10: Closing the Computer
Carefully replace computer cover and reinstall screws, per Owner's
Manual. Now hardware installation is complete.
14
Hardware Installation
Red Edge
CDU948S Drive
Power
Supply
Cable
INTERFACE CONNECTOR
0 1 2
L GND R
5V 5% GND 12V 10%
AUDIO OUT
TEST MODE
PREVENT/ALLOW
DC INPUT
ID SELECT
F.GND
DEVICE TYPE
SCSI
Cable
Red Edge
(Not included)
49
1
2
50
SCSI Card
(Not included)
Software Installation
Please refer to CD-R formatting software manual for instruction on
software installation. CD-R formatting software must first be properly
installed in order to write CD's with the CDU948S drive.
Using Discs and Caddies
Loading a Disc into a Standard Caddy
1
Press both tabs at opposite end to shutter to open caddy lid.
Note:
CD-R disc's recording surface must be clean, please do not touch it.
Data cannot be recorded is CD's recording surface is contaminated.
2
Place a disc, label up, into the caddy.
Software Installation/Using Discs and Caddies
15