Software Installation; Installing The Software Driver For Dos 6.X; Installing The Software Driver For Windows 95 - Sony CDU311 User Manual

Software Installation

The installation diskette enclosed in the package contains two software
items:
Installer
Device driver for MS-DOS/Windows 3.1
Note:
Both Microsoft CD-ROM Extensions (MSCDEX) or equivalent and Sony's
Device Driver are required to run the CDU311 under the MS-DOS and
Windows 3.1 environment.
Therefore, prior to loading the installation diskette, make sure that the
MSCDEX is in the DOS directory of your hard disk drive (C:\DOS).
Although MSCDEX is included in the most up-to-date MS-DOS (ver. 6.2),
you may need to obtain the software from your PC dealer if you do not
have it.
The installer will automatically load MSCDEX via the AUTOEXEC.BAT
file and installs the Device Driver via the CONFIG.SYS file, if MSCDEX
is already in Drive C:\DOS.

Installing the Software Driver for DOS 6.X

Load the diskette into the floppy disk Drive A, and type:
>A:\INSTALL
and then, press the Enter key.
After installation, the following lines are added to CONFIG.SYS and
AUTOEXEC.BAT files.
in CONFIG.SYS:
Device=C:\DEV\ATAPI_CD.SYS /D:mscd000 /I:0
in AUTOEXEC.BAT:
C:\DOS\MSCDEX.EXE /D:mscd000 /M:12 /V
18 Software Installation

Installing the Software Driver for Windows 95

Case 1: Windows 95 standard installation
There should be no problem installing the CD-ROM drive under
Windows 95. The following instructions will guide you through the
installation process. For details on each installation step, please refer
to the relevant note.
After Hardware installation (make sure Master or Slave setting is correct)
Run Windows 95 (see Note a).
• If the CD-ROM device is
recognized by Windows
• If the CD-ROM device is not
recognized by Windows
Click under My Computer; Control Panel; Add New Hardware icon
(see Note b).
• If the CD-ROM device is
recognized by Windows
• If the CD-ROM device is not
recognized by Windows
Start the SETUP.EXE program from the installation disk (see Note c).
• If the CD-ROM device is
recognized by Windows
• If the CD-ROM device is not
recognized by Windows
Get in contact with your dealer to get further instructions.
Note a)
Just start Windows 95 and it should automatically recognize the new
Sony CD-ROM drive and load Windows 32-Bit device driver.
Note b)
Click on the Start, Settings, Control Panel and Add New Hardware icon.
The Add New Hardware Wizard window will appear. Click on the Next
button continuously. Windows 95 will detect the new configuration.
Reboot the computer, run Windows 95 and verify the 8X CD-ROM drive
setting by clicking on the My Computer icon. The CD-ROM drive icon
will appear.
End
See next instruction
End
See next instruction
End
See next instruction
Software Installation 19