Table of Contents
Advertisement
CAUTION!
Do not use abrasive cleaning components,
solvents, steel wool or other abrasive mate-
rials to clean the lenses.
Daytime Running Lights —
If Equipped
The Daytime Running Lights (bright intensity)
come on whenever the engine is running, and
the transmission is not in the PARK position.
The lights will remain on until the ignition is
switched to the OFF or ACC position or the
parking brake is engaged.
The headlight switch must be used for normal
nighttime driving.
Multifunction Lever
The multifunction lever is located on the left side
of the steering column.
Multifunction Lever
High/Low Beam Switch
Push the multifunction lever toward the instru-
ment panel to switch the headlights to high
beams. Pulling the multifunction back toward
the steering wheel will turn the low beams back
on, or shut the high beams off.
Automatic High Beam — If Equipped
The Automatic High Beam Headlamp Control
system provides increased forward lighting at
night by automating high beam control through
the use of a digital camera mounted on the
inside rearview mirror. This camera detects ve-
hicle specific light and automatically switches
from high beams to low beams until the ap-
proaching vehicle is out of view.
NOTE:
• The Automatic High Beam Headlamp Control
can be turned on or off by selecting "ON"
under "Auto High Beam" within your
Uconnect settings, as well as turning the
headlight switch to the AUTO position. Refer
to "Uconnect Settings" in "Multimedia" for
further information.
• Broken, muddy, or obstructed headlights and
taillights of vehicles in the field of view will
cause headlights to remain on longer (closer
to the vehicle). Also, dirt, film, and other
obstructions on the windshield or camera
lens will cause the system to function
improperly.
If the windshield or Automatic High Beam Head-
lamp Control mirror is replaced, the mirror must
be re-aimed to ensure proper performance. See
your local authorized dealer.
Flash-To-Pass
You can signal another vehicle with your head-
lights by lightly pulling the multifunction lever
toward you. This will cause the high beam
headlights to turn on, and remain on, until the
lever is released.
Automatic Headlights — If Equipped
This system automatically turns the headlights
on or off according to ambient light levels. To
turn the system on, rotate the headlight switch to
the A (auto) position.
When the system is on, the Headlight Delay
feature is also on. This means the headlights will
stay on for up to 90 seconds after you turn the
ignition switch to the OFF position. To turn the
automatic headlights off, turn the headlight
switch out of the A (auto) position.
NOTE:
The engine must be running before the head-
lights will turn on in the Automatic Mode.
Parking Lights And Panel Lights
To turn on the parking lights and instru-
ment panel lights, rotate the headlight
switch clockwise. To turn off the park-
ing lights, rotate the headlight switch back to the
O (off) position.
43
Advertisement
Chapters
Table of Contents
