Eco Mode; Steering Wheel Audio Controls - If Equipped - Jeep Grand Cherokee SRT 2018 Owner's Manual

Valet Mode Deactivation PIN
The Valet Mode Deactivation key pad will then
prompt you for your four digit PIN code, enter
your PIN code and press the "OK" button on the
touchscreen.
NOTE:
If your four digit PIN is lost or forgotten, the
vehicle will exit Valet Mode after a battery dis-
connect for approximately one minute. Recon-
nect the battery and cycle the ignition to the
RUN position, the vehicle will be in Default
Mode.

ECO MODE

Eco Mode
Push the ECO button on the center stack of the
instrument panel to enter ECO mode. ECO
mode modifies the vehicle's engine and trans-
mission settings to provide improved fuel
economy at a trade-off with acceleration perfor-
mance. Increased engine exhaust noise and/or
vibration may be noticed while ECO is active.
This is normal and a result of the increased
amount of operating conditions where the ve-
hicle is allowed to operate in four cylinder shutoff
mode.
The Paddle Shifters will be disabled while in
ECO mode.
• ECO will be disabled when another Drive
Mode is selected or ECO button is pushed.
STEERING WHEEL AUDIO
CONTROLS — IF EQUIPPED
The remote sound system controls are located
on the rear surface of the steering wheel. Reach
behind the wheel to access the switches.
Remote Sound System Controls (Back View Of
Steering Wheel)
The right-hand control is a rocker-type switch
with a push-button in the center and controls the
volume and mode of the sound system. Pushing
the top of the rocker switch will increase the
volume, and pushing the bottom of the rocker
switch will decrease the volume.
Pushing the center button will make the radio
switch between the various modes available
(AM/FM/CD/AUX/VES, etc.).
The left-hand control is a rocker-type switch with
a push-button in the center. The function of the
left-hand control is different depending on which
mode you are in.
287