Bandwidth - Stanford Research Systems SIM984 Operation And Service Manual

1.2 Front-Panel Operation

1.2.3 Bandwidth

1.2.4 Output
SIM984 Isolation Amplifier
Figure 1.1: The SIM984 front and rear panels.
User bandwidth settings of DC–100 Hz, DC–10 kHz, and DC–1 MHz
are with the left and right [Bandwidth] buttons.
The amplified, band-limited signal appears at the (ground-referenced)
BNC connectors on the front and rear panels. Each output connec-
tion is through a 50 Ω resistor. For normal operation, the user should
not need to terminate the output. If a 50 Ω termination is applied,
the output signal will be divided in half.
If the output signal exceeds ±10 V, the output overload detection is
activated. This is indicated by the red OVLD near the top of the
"OUTPUT" block on the front panel.
The SIM984 output offset voltage may be trimmed by adjusting the
1 – 3