Uwatec A700 Maintenance Manual page 12

6
Neoprene
A700 Step-by-step maintenance procedures.
30. Check for previous
folds/creases on the
diaphragm "lip".
Any imperfections found
merits replacement.
31. Be certain the entire
circumference of the
diaphragm is laying flat
and into the case
diaphragm groove.
32. With the outside ring
tab @ the 6 o‟clock
position, press the cover
into place, orienting the
bottom of the "S" logo
towards the tab.
33. Place the two piece
assembly, orienting the
ring tab into case notch
located at the "6 o-clock
position".
34. Align one cover hole
with an o-ring.
A neoprene surface is
best!
35. Press the screws, one
by one, through the front
cover hole and through
the new 363 o-rings.
The neoprene provides
just enough support and
give, to allow the screw
to pass through the o-ring
until installed.
12
36. Align the cover (with
screws and o-rings
already installed).
37. Begin to lightly snug
the 4 TORX® screws
down, using an X
tightening pattern.
38. Using Torque driver,
tighten the screw to the
recommended 6.2 inch
pounds / 0.7 Newton
meters. See tool list on
page 2 of this manual.