Uwatec A700 Maintenance Manual page 10

17. Push "micro adjust"
into the "adjustment
shaft" and hold with
finger-pressure.
18. Using a flat blade
screw driver, inserted
through the shaft, turn
the micro adjust
counterclockwise
micro adjust bottoms out.
19. Preset micro-adjust as
pictured below. That is,
bottom out
counterclockwise, and
then advance clockwise
exactly 2 full rotations –
leaving a 1 mm step
See cut-a-way...
1 mm step
20. Screw the adjustment
shaft into the metal
sleeve.
21. It is helpful to
temporarily use the
adjustment knob to finish
– screw until the shaft
bottoms out.
A700 Step-by-step maintenance procedures.
until the
10
22. Prep the „dive switch"
by installing both o-rings
supplied in the
maintenance kit.
Note the shortcut!
Continued...
Lubricate and spread the
new 160 o-ring into place.
Continued...
Repeat and slide the
second o-ring into the
next groove.
23. Push the adjustment
shaft sub-assembly into
the "dive switch".
24. Push until it bottoms
out.
Note: Orient the metal
sleeve tabs "north &
south" in relation to the 2
(long/short) dive switch
guides. The metal sleeve
tabs engage into the case
inlet-tube guides.