Aeromaster Xp Air Handling Unit Adjustable And Fixed Feet - Remak AERO MASTER XP Series Installation And Operating Instructions Manual

AeroMaster XP Air Handling Unit Adjustable and Fixed Feet

Adjustable legs are used for the base frame height of 300mm and 400mm. When levelling the unit due to floor unevenness or other reasons, the
base frame height off-set must not exceed -20 mm to +5 mm. The adjustable legs are provided with a levelling nut and joint. To ensure the unit's
stability, the leg declination must not exceed 10°.
Adjustable feet are delivered separately due to transport safety. For the same reason, the fixed feet of some sections or transport blocks may also
be disassembled in the factory. The customer will install the adjustable or fixed feet himself
Recommended Installation Procedure
 To install the adjustable (see figure # 1) or fixed (see figure # 2) feet to the 150 mm base frame, place the section or transport block of sections
on supports (balks or stands) which must be stable to avoid the section overturning during the feet installation. The supports must be placed
min. 250 mm from the base frame edges.
 Mount the foot using four M8 x 20 screws.
Figure 1
Figure 3
Air Handling units AeroMaster XP
Figure 2
M8 screw
M8 nut Frame height
8 washer adjusting screw
Figure 4
M8 screw
Adjusting screw
securing nut
M8 nut
8 washer
39