Remak AERO MASTER XP Series Installation And Operating Instructions Manual page 32

XPXB 28/BS Plate Heat Exchanger Section
Figure 3 – Air-handling unit top view
Plate Heat Exchanger Installation
 Dismount side panels and panels with handles (see figure # 2).
 Loosen upper screws of braces and connecting frames (see figures
# 4, 5 and 6).

Dismount top panels (on block as one large plate) (see figure # 2).
 From upper side, insert the plate exchanger (see figure #1).
 From upper side, insert the bypass damper (see figure #1).
 Stick the sealing onto the upper edge of the bypass damper (figure
# 1).
 Reinstall top panels - as one plate (see figure # 2).
 Screw in upper screws of braces and connecting frames (see
figures # 4, 5, 6).
 Fix bypass sheets into the space between top panels and ex-
changer - use 4.8 x 16 self-tapping screws (see figure # 1).
 Seal with silicone sealant.
 Slide the drop eliminator into the air-handling unit - guiding bars of
the condensate draining tray (see figure # 1).
 Reinstall and screw on side panels and panels with handles (see
figure # 2)
Note: The panel handles are delivered dismounted to avoid damage
during the transport. The handles and connecting screws are included
in the installation kit. The installation holes for screws in panels are
prepared in the factory.
32
Bypass damper Bypass sheets
Figure 4
Connecting frame screws
Figure 6
Figure
Plate heat exchanger
Figure 5
Connecting frame screws
Brace
screws
Figure
7
Bypass damper
Connecting
frame
screws
8