Advertisement
2.4) Installation procedure for AR261, AR265, AR26116, AR26516 rail web electrical
connections
–
Drill rail web or, if already drilled, use a suitable reamer to clean the hole (Fig. 1).
–
Check the size of the hole with the CAL 22.23 "GO/NO GO" gauge (Fig. 2a):
- The hole size is correct only if the green part enters the hole.
- If the red part enters, the hole is too large, in this case
it is necessary to drill a new hole.
Using the same gauge, check the rail thickness (Fig. 2b):
- If the yellow band protrudes, use the AR 265... series.
- If the yellow band does not protrude, use the AR 261... series.
–
Insert the AR2...-1 copper bush into the rail web hole and position the AR2...-2 copper washer on
the opposite web side (Fig. 3).
–
Ensure that the ram in the head is fully retracted and then fi rmly screw and tighten the stem of the
plunger onto the tool head (Fig. 4).
–
Introduce the stem of the plunger into the AR2...-2 copper washer and tighten the insert of the plunger
OG... onto the stem (Fig. 5) using the recess in the gauge CAL22.23.
Plungers OG13.2T and OG16.2T are composed of 2
separate items: insert and stem.
To rapidly execute subsequent extrusion operations,
it is suffi cient to unscrew the insert, leaving the stem
fi rmly screwed onto the head.
–
Operate the moveable handle of the tool (Fig. 6) to pull the plunger
bush and extrude the bush onto the surface of the hole.
At the end of the operation, press the pressure release lever (20) to retract the ram (01).
– The bush will also extrude itself around the opposite side of the rail web (Fig. 7).
2.5) Conductor assembly
– Crimp the two lugs onto the conductors.
– Assemble all pieces as shown in Fig. 8.
– Fit the self-locking nut (Fig. 9) and tighten to the torque setting indicated.
FIG. 1
insert
FIG. 2a
NO
FIG. 2b
YES
green part
yellow band
stem
OG... completely through the
6
red part
Advertisement
