Lighting Procedure; Shutdown Procedure - Regency Ultimate U39E Series Owners & Installation Manual

Freestanding gas stove

Hide thumbs Also See for Ultimate U39E Series:

Owners & installation manual (64 pages)

Table Of Contents

Table of Contents

Lighting Procedure

IMPORTANT: The remote control system supplied with this appliance has

several options for starting/operating the appliance using the battery holder

and ON/OFF key on the hand held transmitter.

Prior to operating this appliance, please read the remote control operating

instructions (packaged with remote control) to understand how to operate

this remote control system.

1. Ensure the battery holder switch is in the Remote position and / or wall

mounted battery holder (if equipped) is in the <REMOTE> position.

2. Press and release the ON/OFF button on the remote handheld transmitter

(see Diagram 1). An audible beep should be heard from the receiver. If

not using the remote, the unit can also be turned on by sliding the battery

holder switch to the <ON> position (if equipped).

ON/OFF

Button

Diagram 1

Remote shown in Manual Mode on Hi

3. After approximately 4 seconds the spark ignition system will spark for 60

seconds to light the main burner.

4. The unit will turn on.

On Demand Pilot (seven day safety timer)

Important information if using the appliance in CPI (continuous pilot mode) only

This appliance is a ProFlame 2 system fitted with the "On Demand" Pilot, a safety feature which will shut down the gas valve completely by extinguishing the

pilot light in the event of a continuous full seven days of inactivity.

This only applies if the CPI (continuous pilot) switch is in the "on" position in your remote control transmitter.

Each time the main burner shuts down, manually or through the call from the thermostat, the seven day timer starts again.

The seven day inactivity timer is controlled within the circuit board. Therefore, if in CPI mode and when the pilot light is extinguished after seven straight days

of inactivity, the CPI setting on the remote control transmitter will remain in the "CPI" (continuous pilot) position. Therefore, all that is required to relight the pilot

would be to press the on/off button on the remote control transmitter from "on" to "off" and back to "on". Once the pilot has re-established operation will resume

as normal. There is no requirement to do anything with the IPI/CPI mode on the remote control transmitter.

If the unit never goes as long as seven full days without a call for heat, the pilot will remain lit until it is manually shut-off.

If the unit is being operated in IPI (intermittent pilot) mode, neither the above instructions nor the seven day timer will apply.

See the instructions in this manual and on the Lighting Instructions plate on the appliance to light or re-light the pilot.

Note: The first try for ignition will last approximately 60 seconds. If there is no

flame ignition (rectification) the board will stop sparking for approximately

35 seconds. After wait time , the board will start second try for ignition by

sparking for approximately 60 seconds . If there is still no positive ignition

the board will go into lock out.

The system will need to be reset as follows:

a) Turn the system off by pressing the ON/OFF button on the remote.

b) Wait 5 minutes then repeat from step 2.