Table of Contents
Advertisement
installation
First Fire
The FIRST FIRE in your stove is part of the paint
curing process. To ensure that the paint is properly
cured, it is recommended that you burn your fireplace
for at least four (4) hours the first time you use it with
the fan on. When first operated, the unit will release
an odour caused by the curing of the paint and the
burning off of any oils remaining from manufacturing.
Smoke detectors in the house may go off at this
time. Open a few windows to ventilate the room for
a couple of hours. The glass may require cleaning.
DO NOT ATTEMPT TO CLEAN THE GLASS WHILE
IT IS STILL HOT!
Note: When the glass is cold and the appli-
ance is lit, it may cause condensation
and fog the glass. This condensation
is normal and will disappear in a few
minutes as the glass heats up.
DO NOT BURN THE APPLIANCE WITH-
OUT THE GLASS FRONT IN PLACE.
During the first few fires, a white film may
develop on the glass front as part of the curing
process. The glass should be cleaned or the
film will bake on and become very difficult
to remove. Use a non-abrasive cleaner and
NEVER clean the glass while it is hot.
|
42
Regency
U39E-11 ULTIMATE™ Freestanding Gas Stove
®
Operating Instructions
1. Read and understand these instructions before
operating this appliance.
2. Check to see that all wiring is correct and en-
closed to prevent possible shock.
3. Check to ensure there are no gas leaks.
4. Make sure the glass in the door frame is properly
positioned. Never operate the appliance with the
glass removed. Never strike the glass or slam
the door shut.
5. Verify that the venting and cap are unobstructed.
6. Verify log placement. If the pilot cannot be seen
when lighting the unit—the logs have been
incorrectly positioned.
7. The unit should never be turned off, and on
again without a minimum of a 60 second wait.
This remote control requires coding. See remote
coding instructions for details.
NOTE: This appliance will operate with 4 AA back-up
batteries installed (see Back-up Battery section
for details) during power outages. Only the fan
will not operate until power is restored. If the
remote is misplaced, the unit can be shut off
by flipping the main ON/OFF switch, located
behind the front cover plate, to the OFF position.
IMPORTANT: The remote control system supplied
with this appliance has several options for
starting/operating the appliance, please read
the remote control operating instructions
(packed with remote control) to understand
how to operate this remote system. You can
download remote functions video with the QR
code in this manual.
Operation Using an Optional Wall
Thermostat
This unit ships with a full function remote control
as standard equipment. This allows for basic on/off
function as well as the ability to operate as a ther-
mostat. With the addition of an optional wall cradle
(820-477-AWT available from an authorized dealer)
the remote can reside on a wall and carry out all
the functions of a typical millivolt wall thermostat as
well as being able to control the fan speed, and the
flame height. This is the recommended procedure
for operating the unit with a thermostatic set point.
If a millivolt wall thermostat is required for bedroom
installation or as preferred method of controlling the
stove, see noted option.
Wall thermostat and remote. Set the wall thermo-
stat to the desired set point, then place the remote
transmitter in either SMART or thermostatic mode
with a set point 5 degrees above the set point on
the wall thermostat. The burner will fire until the
set point on the wall thermostat is satisfied. The
remote will remain connected and allow full control
of all accessories.
Hide quick links:
Advertisement
Table of Contents
