Disconnect The Power - Emerson 1410H Reference Manual

Configuration
February 2019
Procedure
1. Turn off power to the Gateway, remove connectors, and un-mount the device from
2. Locate the Reset switch label on the back of the Gateway. There is a reset switch for
3. Break the label in the center and slide the switch up.
4. Mount and reconnect the Gateway; turn power ON on to the Gateway.
5. Let the Gateway completely boot up (approximately 2 minutes). During this time
6. Turn off power to the Gateway, remove connectors and un-mount it from the rail
7. Return the Reset switch to lower position.
8. Mount and reconnect the Gateway; turn power ON on to the Gateway.
9. Verify the reset light is off, indicating the Reset switch is in the lower position. The
2.16

Disconnect the power

Disconnect the power and Ethernet cables from the Gateway.
18
the DIN rail.
each network on the left and right sides. If the left side needs to be reset, the left
reset switch should be used. The left switch will only work for the left network.
the red Reset light on the front of the unit will be ON.
again.
Gateway will now be programmed back to factory defaults including IP addresses.
The factory default IP addresses can be found in the table in the Initial connection
section of Troubleshooting.
Reference Manual
00809-0500-4410
Emerson.com/Rosemount