BAFANG BT C01.340.UART Customer's Manual
Front hub motor system
Hide thumbs
Also See for BT C01.340.UART:
- Manual (20 pages) ,
- Manual (48 pages) ,
- Customer's manual (34 pages)
Subscribe to Our Youtube Channel
Related Manuals for BAFANG BT C01.340.UART
Summary of Contents for BAFANG BT C01.340.UART
-
Page 1: Table Of Contents
CONTENT CONTENT 1 Important Notice 6 Displays and settings 2 Introduction 6.1 Normal indication area 2.1 Overview 6.2 Button definition 3 Safety Instructions 6.3 Normal operation 3.1 General information 6.3.1 Power ON / OFF 3.2 For your safety 6.3.2 PAS level selection 3.3 Installation and Maintenance 6.3.3 Lamp/LED display luminance 3.4 Safety Precautions... -
Page 2: Important Notice
1 IMPORTANT NOTICE Important bolted connection! Please adhere This operating manual contains various points to the exact recommended torque when and pointers, providing important information tightening this connection. The correct about your new pedelec and how to use it, mounting torque is either displayed on the referring to possible damage to property and the component or listed in the “Bolted connections”... -
Page 3: Introduction
INTROdUCTION 2 INTRODUCTION 2.1 Overview This part of the operating instructions gives you specific information on how to handle the electrical drive unit components and how to drive a Pedelec. For general information, e. g. for pedelec technology, please refer to the enclosed instructions. -
Page 4: Safety Instructions
• It is recommended that you only use genu- pedelec before riding it. If the pedelec starts ine BAFANG parts. off suddenly, accidents may occur. • The pedelec may suddenly fall over and • Make sure the pedelec's lights are on before serious injury may occur if nuts and bolts are riding at night. -
Page 5: Installation And Maintenance
SAFETY INSTRUCTIONS 3.3 Installation and instructions concerning use of the product by a person responsible for their safety. Maintenance • do not allow children to play near the product. It is vital that all bolted connections on the • Should you encounter any errors or prob- pedelec have the correct torque in order to lems, consult your nearest dealer. -
Page 6: Quick Start
• Natural wear and tear due to normal use Please also consult the additional operating manuals, issued by the individual component and aging is not within our scope of our manufacturers and which were supplied with quality warranty. your pedelec or are available online. Your •... -
Page 7: Legal Regulations
SAFETY INSTRUCTIONS 3.8 Legal Regulations Before every ride, please check that: • The lights and bell are working and are safely secured. Please stay informed about the national regulations applicable in your specific country. • The brakes are working safely and are prop- erly secured. -
Page 8: Electronic Components
4 ELECTRONIC COMPONENTS In order to prevent a malfunction, the following be voided. If non-original or incorrect spare parts instructions should be observed: are used, the pedelec may not function correctly. In the event of a defect, contact an authorized •... -
Page 9: Batteries
, fire or explosion. specifications can be found in the table below. In case of drop, shock or similar event, do not Model numbers: BT C01.340.UART, BT C01.450. continue to use battery and return immediately UART for examination. -
Page 10: Notification
4.3.2 Notification A special charger provided by BAFANG must be used to charge these batteries. • The battery should not be left in direct sun- light so as to avoid over-heating, distortion, • do not charge the battery for longer than... -
Page 11: Caution
ELECTRONIC COMPONENTS 4.3.3 Caution Do not damage the battery. do not allow the battery to be gouged, Do not disassemble the battery. forged or dropped, as this may cause it to The battery contains protective components over-heat, distort, smoke or burn, and and will internally short-circuit to avoid danger. -
Page 12: Specifications
4.3.4 Specifications Basic settings BT C01.340.UART BT C01.450.UART Power 340 Wh 450 Wh Charging time 4.5 h with a 2A Charger 6.5 h with a 2A Charger Operating Temperature during 0° ~ 45 °C 0° ~ 45 °C Charging discharge -20°... -
Page 13: Hub Motor
ELECTRONIC COMPONENTS • When you clean the charger, unplug it from the electrical socket first. • When charging takes longer than shown in the specifications table, stop charging. • After charging, remove the battery from the charger and unplug the charger. 4.5 Hub motor Your Pedelec is equipped with a 250 Watt front-wheel electric motor, which also forms the... -
Page 14: Operation
5 OPERATION 5.1 Installing the battery 3. Remove the battery from the casing/battery holder. For correct insertion, the battery must be Hold the battery tightly as it is heavy. inserted and locked from the rear of the casing as far as it will go. Without contact with the battery, the electric drive of your pedelec will 5.3 LED capacity and state not work. -
Page 15: Charging The Battery
OPERATION LED state NOTES When the system is First LEd flickers ≤ 5 % triggered in operation mode: Press the button for 1 second for One green light 5<L<10% the BMS to display the charge of the battery on Two green lights 10≤... - Page 16 Errors – Causes and Solutions Error description Cause Solution Check all connections and whether The operating display does Mains plug not properly con- the charger is properly connected to not light up nected to the power supply the power supply The charging indicator is The battery may have a Contact the manufacturer or your...
-
Page 17: Switching The Electrical System On And Off
OPERATION 5.5 Switching the electrical You can switch the electrical system of your Pe- delec on and off according to the description on system on and off the control unit, see section "Control element". If the battery of your Pedelec is equipped with an Make sure that the pedals of your Pedelec are on/off switch, you can also press the switch on not weighed down when the system is turned... -
Page 18: Displays And Settings
6 DISPLAYS AND SETTINGS 6.1 Normal indication area • PAS level indication: Indicate current PAS level 0~5; if no LEd display, it mean it is level 0; 1~5 is in accordance with the PAS level.In the mode of Push Assistance, LEd loop light Light sensor one by one from down to up with 0.5s time under... -
Page 19: Button Definition
dISPLAYS ANd SETTINGS 6.2 Button definition 6.3 Normal operation 6.3.1 Power on/off press for 2s, the display will turn ON; Level "+" & press for 2s, the display will turn OFF. It headlight will automatically turn OFF when standby in 5 minutes. -
Page 20: Error Code Definition
6.4 Error code definition This system can indicate all errors occurring on the Pedelec. In certain modes, the LEds will flicker when an error code occurs. Error code Error definition Solution The second LEd flickers 7 times in High voltage protection Check the battery voltage rapid succession The second LEd flickers 8 times in... -
Page 21: Range Of Your Pedelec
dISPLAYS ANd SETTINGS 6.5 Range of your Pedelec Weather and vehicle weight: In addition to the ambient temperature, wind conditions also influence the range. A strong headwind requires Range data is based on optimal conditions. This more power when driving. Baggage, etc. will can be influenced by the following factors: increase the weight and therefore more force is Level of assistance: The higher the assistance... -
Page 22: Maintenance And Repairs
7 MAINTENANCE AND REPAIRS 7.2 Battery wear Keep the all components of the electrical system clean. Clean gently with a damp, soft cloth. The components must not be immersed in water or The battery can run for approx. 500 charging. cleaned with a water jet or steam jet. -
Page 23: Customer Service
CUSTOMER SERVICE 8 CUSTOMER SERVICE If you have any questions concerning the electri- cal system, please contact the manufacturer or your specialist dealer. CUSTOMER MANUAL FRONT HUB MOTOR SYSTEM... -
Page 24: Transporting The Pedelec
9 TRANSPORTING THE PEDELEC 9.2 By public transport Remove the battery before transportation and transport it separately. Cover the contacts with a transport cap to prevent the risk of a short The same regulations apply as when transporting circuit. In the case of a short circuit, there is a a bicycle. -
Page 25: Disposal Considerations
dISPOSAL CONSIdERATIONS 10 DISPOSAL CONSIDERATIONS If parts of your Pedelec are replaced, please take According to European directive 2006/66/EC, defective or used batteries must not be used, note of the waste disposal instructions for your and, in accordance with the European directive local waste disposal company. -
Page 26: Specifications
Brake: Roller-Brake Weight: 2.3 KG Installation Width: 100 mm Max. Housing diameter: 138 mm Cabling Shaft Side: Right Spoke Specification: 13 G Battery Basic settings BT C01.340.UART BT C01.450.UART Nominal Voltage: 43 dCV 43 dCV Nominal Capacity: 7.8 Ah 10.4 Ah... - Page 27 SPECIFICATIONS Basic settings BT C01.340.UART BT C01.450.UART Operating Temperature during 0° ~ 45 °C 0° ~ 45 °C Charging discharge -20° ~ 60 °C -20° ~ 60 °C Storage (At 35 % SOC ,-10 ~ 35 °C) 6 Months 6 Months 500 (60 % SOC (@20 ±...
-
Page 28: After-Sales And Warranty Policy
Under EU law, the seller accepts liability for ma- The BAFANG limited warranty does not cover or terial defects for at least two years after the date apply to the following situations: of sale. This also covers defects which already existed at the time of sale/change of ownership. -
Page 29: Imprint
Legal inspection by a lawyer’s office specialis- rent Chinese law, the Chinese law shall prevail. ing in intellectual property. BAFANG reserves the right to modify the terms In the case of delivery or use of this product without prior notice. - Page 30 NOTES CUSTOMER MANUAL FRONT HUB MOTOR SYSTEM...
- Page 31 NOTES CUSTOMER MANUAL FRONT HUB MOTOR SYSTEM...
- Page 32 NOTES CUSTOMER MANUAL FRONT HUB MOTOR SYSTEM...
Need help?
Do you have a question about the BT C01.340.UART and is the answer not in the manual?
Questions and answers