Exw Trend - Special - Boqballe EX Manual

EX(W)
Trend
EXW
BØGBALLE
The EXW machine is equipped with one parallel mounted 6 tons stainless weight cell,
which makes it possible together with CALIBRATOR – to have complete control during
the field work.
The weighing system is so constructed that the parallel mounted hopper and spreading
system is carried through 2 blade springs and 2 bearings – supported by only one weight
cell.
•
The parallel construction ensures that the weight is always correct and stable – no
matter where in the hopper the load is placed. This way a maximum precision is
ensured independent of load circumstances.
•
The parallel construction ensures moreover that the precision in the weighing result ist
within ± 1%, even in case it goes uphill or downhill with gradients of 7-8% (6°-7°).
The maximum hopper contents of the EXW machine is 2.500 kg. Together with the weight of the machine it
makes a total load of approx. 3.000 kg. In case the ground is very uneven it means that the weight cell is up against
loads of 2 x the total load – say 2 x 3.000 kg = 6.000 kg. This way the load of the weight cell will correspond to
the max load of the weight cell – for which reason defects might arise if the maximum hopper contents is
exceeded.
The EXW machine will "settle" after
spreading 5 – 10 tonnes of fertiliser.
This means that the 0- point can be
moved.
Is this the case make a calibration /
0-setting of the system.
(See Operator's Manual
CALIBRATOR)
The blade springs must always be
horizontal in comparison to the
chassis tube. If this is not the case –
adjust the system by the adjustment
bolt.
After adjustment the system must
always be calibrated.
The safety bolt must when the
machine is mounted on a tractor, have
a distance to the chassis tube of 3 - 5
mm.
The bearing should not be washed
directly with water – and special care
must be taken when cleaning the
weight cell.
Possible defects due to water, are not
under warranty.
EXW
Trend
Trend
..........the ultimative solution!
for the
– special
Safety bolt
37
Blade spring
Weight cell
Adjustment bolt
Bearing