Normal Spreading; Practical Test - Boqballe EX Manual

Hide thumbs

Table Of Contents

Table of Contents

EX(W)

Trend

At the NORMAL spreading the machine is set as

stated under the paragraphs:

The machine setting is based on spread tests made in BØGBALLE's test hall. The

spreading abilities of the fertiliser in question may vary in comparison to the abilities of the

fertiliser which was tested at BØGBALLE – which formed the basis for the spread chart.

The 4-double overlap of the machine, and the "power suplus" of the spreading system – in such cases

gives extra tolerance for achieving a good spreading result – normally without making corrections to

the recommended setting.

The only correction that can be made is – change of the TILT-ANGLE of the machine.

Under normal conditions the machine settings recommended in the Operator's Manual and the

Spread Charts of the spreader should not be changed – unless the fertiliser in question is not

stated in the spread chart or that the nature/quality deviates from "what you should expect"!

PRACTICAL TEST

In case you want to make a practical test in the field, it is possible to place test trays

such test must be carried out very carefully – and the test may if it is not done correctly – be

misleading.

Guidance is found under "TEST WITH TEST TRAYS".

Are not sold by BOGBALLE – information can be obtained from your dealer.

The test has the primary purpose – by adjustment of the TILT angle of the machine – to

ensure a correct spread width and thus a optimum overlap

following pages).

The 4-double overlap means that no kind of side adjustment is necessary.

As main rule the spread width will:

In case you have no test trays available the spread width can be checked by ensuring that fertiliser is

spread – as a minimum to the middle of the next tramline.