Guarantee / Responsibility; Generally; Safety And Protection Against Accident - Boqballe EX Manual

EX(W)
Trend

GUARANTEE / RESPONSIBILITY

• Claim conditions are according to Danish legislation. Service and repair are made free
of cost within 12 months from date of purchase on the following conditions:
•
That the failure is due to construction or material faults
(Normal wear, missing maintenance and misuse not included).
•
That the failure is not due to not original components / equipments.
•
That persons with no technical knowledge to the machine have not tried to repair.
•
Compensation for person or crop injury do not fall on the supplier.
This machine is intended for spreading all common types of fertiliser.
Spreading of other flowing materials might also be possible. If so we draw the attention to
data list of the material concerned in order to determine possible safety or health measures
to be taken.
If the machine is used for spreading material which is not defined in the spread charts for
the spreader, the manufacturer of the machine can never be held responsible.
The transmission system of the machine:
PTO shaft, friction clutch and spreading discs w/vanes – must be considered"as
dangerous", and absolute care must be taken with these machine parts, especially in
connection with rotation of the tractor PTO system.
DO NOT LEAVE THE TRACTOR CABIN – WITHOUT STOPPING THE PTO
•
Never go behind the machine – with rotating spreading discs.
•
Never go under the machine – with rotating spreading discs.
•
Never clean the machine - with rotating spreading discs.
•
Never put hand/object into the hopper – with rotating spreading discs.
•
Always check that the spreading vanes are correctly fixed.
•
Check that the protection tubes of the PTO are intact.
•
Check that the security chain of the PTO is fixed.
•
Check that top link and top link pins are intact and secured by lynch pin.
•
Check that lift arms and link pins are secured by lynch pin.

GENERALLY

SAFETY and PROTECTION
SYSTEM OF THE TRACTOR!
Except when you have to calibrate the machine.
8