Vane / Spread Widht - Boqballe EX Manual

EX(W)
Trend
VANE / SPREAD WIDTH Setting
The vanes are mounted as standard in POS. 1-2
When mounting the fixing bolt must be pulled fully out into the
U-shaped cut before tightening the nut.
One vane in POS. 1
One vane in POS. 2
If in special cases it is
necessary to mount the
vanes in an alternative
position – this
appear from the spread
chart in question.
Vane "TYPE"
The spreading vanes are made in such a way that they are mounted in POS. 1-2, no matter
which type of fertiliser is used – and no matter which quantity is spread. This means in practice
that the spreading vane should only be "moved / demounted" in case a calibration or emptying
of the hopper is made.
Take care that the vanes are mounted and fixed correctly !
The vanes are TYPE- MARKED respectively:
"R" (Right)
"L" (Left)
The vane TYPE is chosen in relation to the required spread width. The vanes are developed in
such a way that only three diferent vane types are covering spead width from 12 to 36 metres.
Below is shown spread width / vane type for the main fertiliser types in the market.
If there are deviations from this it will appear on the spread chart in question.
VANE TYPE
Trend
(Normal / headland vane)
Trend
(Normal / headland vane)
Trend
(Normal / headland vane)
On each spreading disc
will
For right spreading disc – seen from behind
For l
eft speading disc – seen from behind
SPREAD WIDTH
E1T
E2T
E6T
POS. 1 - 2
V (L)
12 – 18 metres
20 – 24 metres
28 – 36 metres
17
U- cut
POS.-
guidance is
shown on a label
fixed to the machine.
H (R)
E( )T-R
E( )T-L
MARK
E1T
R or L respectively
E2T
R or L respectively
E6T
R or L respectively