Setting System - Boqballe EX Manual

EX(W)
Trend

SETTING SYSTEM

The setting system consists of a setting handle, different connection rods and outlet
shutters.
Pos. 1
SETTING HANDLE , Hydraulic/CALIBRATOR
The connection rod of the setting handle must be
mounted in such a way that the shutters of the spreader
are closed – when the setting handle is placed on the
scale ciffer "0".
The adjustment is made on the connection rod.
Connection rod
As standard the connection rod is mounted in Pos. 1
(Ø8 mm.)
Pos. 2
In case very large quantities being used on 28 – 36
metres' spread width, a Pos. 2 connection rod
(Ø10 mm.)
can be used as option.
ADJUSTMENT SHUTTERS
The shutters in the adjustment system are factory set so
that the machine distributes the fertiliser symmetrically.
That means that the fertiliser is shared in equal quantities
to each side of the machine.
The adjustment shutters must be adjusted so that the
shutters close exactly in the middle of the V-mark of
the bottom plate.
Normally you should not adjust the 4 connection rods
connecting the adjustment axle of the machine and the
shutters of the machine. These connection rods should
V-
mark
only be adjusted in case the system has been dismantled
and therefore misadjusted.
The setting is of great importance for the symmetry of the spread pattern.
Be aware that the adjustment shutters do not open equally in comparison to the V-mark.
This assymmetric function ensures automatic adjustment of the feed point for precise
spreading.
10