Table of Contents
Advertisement
5. Either pass the 6" antenna lead along with the
connector through the center hole, or, lay the
6" antenna lead into the cable opening in the
base gasket. Place the antenna, base, and base
gasket on the mounting surface aligning it to
the marks made in step 3.
6. Use the provided mounting screws (or other
stainless steel hardware, not provided) to
mount the antenna to the surface. Do not over-
tighten the screws.
7. Connect the antenna cable to the 6" antenna
lead.
8. Route the antenna cable to the BBWX4
Receiver and connect the antenna cable to the
SMA to SMB Adapter. Connect the adapter
to the Antenna connection of the BBWX4
Receiver.
Pedestal Mount
1. If you are going to route the antenna cable
through the mounting surface, drill a 9/16"
mounting hole. When drilling fiberglass
surfaces, use a small backup block of scrap
wood to control push-through splintering. Use
caution to avoid drilling through or near fuel
lines, fuel tanks, hydraulic lines, or electrical
wiring.
2. Assemble the antenna as shown:
a. Attach the antenna to the base with the
lock washer and retaining nut.
Antenna
Base
Lock Washer
Retaining Nut
Base Gasket
Pedestal Top
Rubber O-Ring
Pedestal Bottom
Cable Knockout
(3 available
use only one)
Pedestal Gasket
Mounting Holes
for Low Profile
Surface Mount &
Pedestal Mount
Cable Opening
Cable Groove
6" Antenna Lead
Advertisement
Table of Contents
