Furuno BBWX4 SiriusXM Installation Instructions Manual page 16

Marine weather & audio receiver
Hide thumbs Also See for BBWX4 SiriusXM:
  • Faq (5 pages)
Table of Contents

Advertisement

Installing the Antenna
In-box antenna mounting options are surface mount,
low-profile surface mount, or pedestal mount.
Optional mounting options require an extension
mast, or a Shakespeare Style 4720 Rail Mount (each
sold separately).
Always mount the antenna so that it does not
interfere with safe operation of the vessel.
Important: When mounting to a surface using the
low-profile, pedestal, or extension mast mounting
method where the antenna cable will exit above
the mounting surface, orient the base or pedestal
bottom so that the antenna cable exits towards the
rear of the vessel, away from oncoming wind from
normal vessel motion.
The following accessories are available from
Shakespeare:
• SRS-3-KIT - Marine SiriusXM Splitter. Kit to
connect two SiriusXM satellite receivers to
one antenna. Includes three 25' cables which
permit up to a 50' cable run from the antenna
to each receiver.
• SRC-35 - 35' Marine SiriusXM Replacement
Cable
• SRC-50 - 50' Marine SiriusXM Replacement
Cable
• SRC-90 - 90' Marine SiriusXM Replacement
Cable
Follow the instructions in the next sections for the
mounting method you've selected. Do not cut the
6" antenna lead or remove the connectors from
any of the cables under any circumstances.
Surface Mount
1. Drill a 9/16" mounting hole. When drilling
fiberglass surfaces, use a small backup block
of scrap wood underneath to control push-
through splintering. Use caution to avoid
drilling through or near fuel lines, fuel tanks,
hydraulic lines, or electrical wiring.
Antenna
Extension
Shaft
Lock
Washer
Retaining
Nut
2. For mounting surfaces greater than 1/4"
thick (up to 1" thick), use the extension shaft
(provided), otherwise continue with step 3.
a. Route the 6" antenna lead with TNC female
connector through the center of the
extension shaft.
b. Thread the extension shaft onto the
existing antenna shaft and tighten.
3. Pass the 6" antenna lead connector and cable,
and extension shaft (if used), through the hole
6" Antenna
Lead
Mounting
Surface
Antenna
Cable

Advertisement

Table of Contents
loading

Table of Contents