Channel-Specific Diameter/Radius Programming (Diamon, Diam90, Diamof, Diamcycof) - Siemens Sinumerik 840D sl Programming Manual

References
● Function Manual, Basic Functions; Speeds, Setpoint/Actual-Value System, Closed-Loop
Control (G2), Section "Metric/inch dimension system"
● Programming Manual, Job Planning; Section "Motion-synchronous actions"
● Function Manual, Synchronized Actions
9.3.6 Channel-specific diameter/radius programming (DIAMON, DIAM90, DIAMOF,
DIAMCYCOF)
During turning, the dimensions for the transverse axis can be specified in the diameter (
in the radius (
So that the dimensions from a technical drawing can be transferred directly (without
conversion) to the NC program, channel-specific diameter or radius programming is activated
using the modal commands DIAMON, DIAM90, DIAMOF, and DIAMCYCOF.
Note
The channel-specific diameter/radius programming refers to the geometry axis defined as
transverse axis via MD20100 $MC_DIAMETER_AX_DEF (→ see machine manufacturer's
specifications).
Only one transverse axis per channel can be defined via MD20100.
Syntax
DIAMON
DIAM90
DIAMOF
Fundamentals
Programming Manual, 01/2015, 6FC5398-1BP40-5BA2
②
):
Geometry settings
9.3 Dimensions
①
) or
155