Panasonic U-8ME1E81 Service Manual page 40

3. Detailed Settings Function
3. Detailed Settings Function
Low Silhouette Ducted Type (Type F2)
Operating the Remote Controller
<Procedure of CZ-RTC2>
1. Press and hold down the
simultaneously for 4 or more seconds.
( , the Unit No., Item Code and Detailed Data will
blink on the remote controller's LCD display.)
2. The indoor unit numbers in the group control will be
sequentially displayed whenever the Unit Select button is
pressed
Only the fan motor for the selected indoor unit will operate
during this.
3. Specify the "
/
buttons and confirm the values.
(" " set at shipment )
4. Press the
values for the set data.
Refer to table at right and select a value between
" " and "
1
Select "
activated.
5. Press the
The display will stop blinking and remain illuminated.
6. Press the
2
and the LCD display will return to the normal stop mode.
Auto Airflow Volume Control Operations and
External Static Pressure Setting-Check Operation
1. Press and hold down the
3
seconds. "
controller's LCD display.
2. Press the
[Test Run] will be displayed on the remote controller's LCD
display.
4
3. Select the fan mode and set it to "H" by pressing the
button.
CAUTION
5
Auto airflow volume control operations and external static
pressure setting-check operations will not be performed
unless [H] has been selected for the fan mode.
The fan motor will be activated and auto airflow volume
4.
control operations or external static pressure setting-check
operations will commence.
6
The power of the airflow will change while these operations
are in progress.
The external static pressure setting-check operations and
auto airflow volume control operations will be completed in
about 3 to 30 minutes.
7
The " " display will be extinguished from the remote
controller's LCD display.
5. Press the
8
, and
.
" item code by pressing the
buttons for the temperature setting
/ buttons for the time to amend the
".
" if the auto airflow volume setting is
button.
button. The fan motor will stop operating
button for 4 or more
" will be displayed on the remote
button to commence the test run.
button to halt the test run.
Table of setting the external static pressure
15, 22, 28, 36, 45,
56, 60, 73, 90
External static pressure of the rated
buttons
air flow volume
150 Pa
140 Pa
130 Pa
120 Pa
100 Pa
70 Pa
60 Pa
50 Pa
30 Pa
10 Pa
No auto airflow volume setting
Auto airflow volume setting
1
* Failure to set this parameter may result in decreased
airflow and condensation.
2-18
Remote Controller Functions
Remote Controller Functions
Indoor unit
106, 140, 160
150 Pa
140 Pa
130 Pa
120 Pa
110 Pa
100 Pa
70 Pa
50 Pa
30 Pa
10 Pa
5
6 1
4
1
2WAY SYSTEM
2WAY SYSTEM
Item code
b0
2
3
3
5
2