Remote Controller Test Run Settings; Wired Remote Controller Test Run Settings; Remote Controller Functions - Panasonic U-8ME1E81 Service Manual

1. Remote Controller Test Run Settings

1. Remote Controller Test Run Settings

Wired Remote Controller Test Run Settings

<Procedure of CZ-RTC2>
1. Press the remote controller
2. "TEST" appears on the LCD display while the test run is in progress.
3. Then press the
The temperature cannot be adjusted in Test Run mode.
(This mode places a heavy load on the machines. Therefore use it only when performing the test run.)
The test run can be performed using the HEAT, COOL, or FAN operation modes.
The outdoor units will not operate for approximately 3 minutes after the power is turned ON and after operation
is stopped.
If correct operation is not possible, an error code is displayed on the remote controller LCD display.
(Refer to "Table of Self-Diagnostic Functions" and correct the problem.)
4. After the test run is completed, press the
To prevent continuous test runs, this remote controller includes a timer function that cancels the test run after 60 minutes.
The operation is possible even if the cassette-type ceiling panel has not been installed. ("P09" display does not occur.)
1
<Procedure of CZ-RTC3>
1. Keep pressing the
buttons simultaneously for 4 or more seconds.
The "Maintenance func" screen appears on the
2
LCD display.
Maintenance func
1. Outdoor unit error data
2. Service contact
3. RC setting mode
4.Test run
3
Sel.
2. Press the
menu.
If you wish to see the next screen instantly, press
4
the or
Select "4. Test run" on the LCD display and press
the button.
Maintenance func
5
1. Outdoor unit error data
2. Service contact
3. RC setting mode
4.Test run
Sel.
6
Change the display from OFF to ON by pressing
the or
button.
Test run
7
Change
8
button for 4 seconds or longer.
button.
, and
20:30 (THU)
Page [ ] Confirm
or button to see each
button.
20:30 (THU)
Page [ ] Confirm
button. Then press the
20:30 (THU)
Test run
ON
[ ] Confirm
button again. Check that "TEST" disappears from the LCD display.
3. Press the
on the LCD display.
4. Press the
Test run setting mode screen appears on the LCD
display.
2-2

Remote Controller Functions

Remote Controller Functions
20:30 (THU)
[ ]
START
button. "TEST" will be displayed
20:30 (THU)
TEST
[ ] START
button. Test run will be started.
20:30 (THU)
TEST
MODE FAN SPEED
COOL
FLAP
2WAY SYSTEM
2WAY SYSTEM
CZ-RTC3