Table of Contents
Advertisement
2 Transport
2.1 Transport
Special tools, Material, Spare parts
Designation / Use
Crossbeam
Crossbeam
DANGER
Suspended load.
Danger to life!
• Use suitable equipment and lifting devices.
• Never stand beneath a suspended load and keep a safe distance.
• Wear personal protective equipment (e.g. protective helmet, safety shoes).
Transport
1.
Install the engine mount locking devices (→ Page 32) and the transport locking device for the engine prior
to transportation (→ Page 29).
2.
Always use the lifting eyes provided when transporting the engine. See lifting requirements (→ Page 24).
3.
The exhaust gas aftertreatment system may be transported on a module frame. The SCR and DPF systems
can also be transported individually.
4.
Use the four lifting points provided to transport the exhaust gas aftertreatment system. See lifting require-
ments (→ Page 24).
5.
Use suitable transport and lifting gear only.
6.
Transport the exhaust gas aftertreatment system / engine in their intended installation positions only: Maxi-
mum admissible diagonal pull is 10° and 5° respectively. See lifting requirements (→ Page 24).
7.
Remove any loose parts on the exhaust gas aftertreatment system / engine.
8.
Always raise/lower the exhaust gas aftertreatment system / engine slowly. The lifting ropes or chains must
not touch the exhaust gas aftertreatment system / engine or their components when lifting. Readjust lifting
tackle as necessary.
9.
For special packaging with aluminum foil: Suspend the engine by the lifting eyes on the bearing pedestal or
transport by means of handling equipment (forklift truck) capable of bearing the load.
10.
Secure the engine / exhaust gas aftertreatment system against tipping during transportation. Secure such
as to preclude slipping and tipping when driving up or down inclines and ramps.
Placement after transport
1.
Only set the exhaust gas aftertreatment system / engine down on a firm, level surface. The surface must not
have any bumps, steps / platforms or objects lying on it.
2.
Make sure that the consistency and load-bearing capacity of the ground or support surface is adequate.
3.
Never set the engine down on its oil pan unless expressly authorized to do so by MTU.
4.
Set down the exhaust gas aftertreatment system in such a way that only the mounts, not the main body,
touch the ground.
5.
Do not set down the exhaust gas aftertreatment system in an inclined position to avoid damaging the system
and the mounts.
Part No.
T80092360
T80090392
MS15065/01E 2019-01 | Transport | 23
Qty.
1
1
Advertisement
Table of Contents
