Table of Contents
Advertisement
11 SPARES & ACCESSORIES
11.1 TRANSDUCERS
Elcometer NDT gauges are not supplied with a transducer as standard - this must be ordered separately.
The transducers listed below are the most commonly used however, Elcometer NDT offer a wide range of
other transducers to suit various applications.
Further information on the transducers available and their applications can be found on the Elcometer NDT
Knowledge Centre on www.elcometerndt.com.
Description
2.25 MHz 1/4" Potted Side Transducer
5 MHz 1/4" Potted Side Transducer
5 MHz 1/4" Potted Side High Damped Transducer
7 MHz 1/4" Potted Side High Damped Transducer
10 MHz 1/4" Potted Side Transducer
11.2 CALIBRATION BLOCKS
Elcometer NDT offer a comprehensive range of calibration blocks to suit a wide range of applications and
standards.
Selecting the correct calibration block for the application is essential to ensure accurate evaluation. The
form, shape and material of the calibration block should be appropriate for the material being inspected.
Any artificially induced flaw should closely resemble that of the actual flaw being tested for.
The calibration blocks listed below are a selection of those available - details of the full range can be found
on www.elcometerndt.com.
Sales Part No.
TX2M25CP-2
TX5M00CP-4
TX5M00CP-10
TX7M50CP-6
TX10M0CP-4
16
Advertisement
Table of Contents
