Ultium EMG Quick Start Guide
4 Configuring the Hardware
Before the Ultium system can be used, the device software settings must be configured to recognize the
different components that make up the system. Follow the below instructions to update the receiver
firmware, sensor firmware, and populate sensors to prepare for a data collection.
Step 1
Open MR3, typically listed under Noraxon ->
MR3
Click on the Hardware Setup
Hardware Setup button in the upper
Hardware Setup
Hardware Setup
right hand corner.
Step 2
Select the Ultium icon, within the 'New Device'
column, and click on the Insert
Insert button.
Insert
Insert
Note: Make sure the Receiver is connected to the
USB port of the computer via USB Cable (CBL2).
Step 3
The Ultium Settings dialog will appear as shown.
Within the 'General Tab'
General Tab', select the desired
General Tab'
General Tab'
collection Sampling Rate.
If using MyoSync, check the Use Noraxon
MyoSync checkbox (see the Ultium EMG User
Manual for more information).
Note: Firmware updates for the Receiver will be
indicated here, if they are required.
(Rev A)
'New Device'
'New Device'
'New Device'
7