Recording A Measurement - Noraxon Ultium EMG System Quick Start Manual

Ultium EMG Quick Start Guide

5 Recording a Measurement

Step 1
Within the Home screen, click on the
myoMUSCLE module icon.
Create a New Subject
Select New Configuration. New Configuration. New Configuration. New Configuration.
Step 2
Insert the devices to be used for the
measurement into the configuration by dragging a
device in from the list of Available Available d d d d ev ev ev evices Available Available
Use the sensor list to select or deselect the
number of sensors to be used within the
configuration. While the sensor is selected, assign
a name to the channel by selecting the
corresponding muscle on the 3D Muscle Map
entering the name manually.
Continue to the next step by selecting Measure.
Step 3
After checking for normal signal display, you are
ready to record a measurement. Select Record
the top left of the screen and begin your protocol.
After completing your record, select Stop
Save Save. Save the record as the name of your
Save Save
configuration, or type in a new name. After this,
save your record or Discard & measure again. Discard & measure again. Discard & measure again. Discard & measure again.
(Rev A)
ices ices. ices
3D Muscle Map or 3D Muscle Map 3D Muscle Map
Measure. Measure. Measure.
Record at Record Record
Stop and Stop Stop
10