Noraxon Ultium EMG System Quick Start Manual page 9

Ultium EMG Quick Start Guide
Step 7
Click on OK (in the bottom of the dialog box)
when done.
Note: Sensor serial numbers appear in the order
that they are placed in the charging doc, starting
at the end with the LEDs (opposite of the
charging port).
4.1 Configuration using Ultium Smart Leads
If you are only using the sEMG SmartLeads,
continue to Section 5: Recording a
Measurement.
Make sure the Smart Lead is connected to the
Ultium sensor before choosing Detect Sensors
in Charger. The Ultium sensor LED will flash
purple when a Smart Lead is connected, and
orange when the Smart Lead is disconnected.
If the software does not recognize the Smart
Lead, the sensors may require a firmware
update. Follow the instructions for Device
Software (firmware) updates.
The Smart Lead will appear using the serial
number of the Smart Lead, and not the Ultium
sensor.
Click on O O O O k k k k (in the bottom of the dialog box)
when done.
(Rev A)
9