Replacing Tilt Bracket; Replacing Seat Support - Invacare Storm4 Series Service Manual

Invacare® Storm⁴ Series
Removing Tilt Actuator
1. Remove legrests.
2. Unplug actuator plug out of module.
3. Remove cable ties.
4. Remove cable.
5. Remove upper pin retainer clip A.
6. Remove upper pin B and tip tilt actuator E forward.
7. Remove lower pin retainer clip D.
8. Remove lower pin C and tilt actuator.
9. Replace tilt actuator.
Installing Tilt Actuator
1. Install parts in reverse order.
2. Test all functions.

6.12.4 Replacing Tilt Bracket

CAUTION!
Risk of strains from lifting heavy parts!
– Use proper lifting techniques.
We use different types of tilt carriers in our mobility devices. Due to this fact the carrier on your mobility device may look
different to the illustrations below. The following mounting instructions are not affected by this.
• 6 mm Allen key
Removing Tilt Bracket
1. Remove seat frame. See Replacing Seat Frame.
2. Remove tilt spindle or tilt actuator. See 6.12.2 Replacing
Tilt Spindle, page 53 (manual tilt) or 6.12.3 Replacing
Tilt Actuator, page 53 (powered tilt).
3. Loosen and remove screw E, washer D and bushing C
on both sides of seat support A.
4. Replace tilt bracket B.
Installing Tilt Bracket
1. Install parts in reverse order. Ensure that holes of tilt
sheet H and seat frame are in line.
2. Test all functions.

6.12.5 Replacing Seat Support

CAUTION!
Risk of strains from lifting heavy parts!
– Use proper lifting techniques.
54
Fig. 6-57
Fig. 6-58 Schematic diagram of a tilt bracket
1555830-C