Advertisement
INSTALLATION
INSTALLATION COMPLIANCE: Galvin Specialised products must be installed in accordance with these
installation instructions and in accordance with AS/NZS 3500, the PCA and your local regulatory requirements.
Water and/or electrical supply conditions must also comply to the applicable national and/or state standards.
Failing to comply with these provisions shall void the product warranty and may affect the performance of the
product.
1. Measure and cut support rod
Measure the distance between the wall
mounting surface and the centre line of the
drilled hole in the bench/trough (dimension "A").
Take dimensions "A" and subtract 16mm. This
is the required length of the support rod
(Required support rod length = A-16mm).
Cut the support rod accordingly; ensure the
threaded end is NOT cut off.
Note: Distance "A" must be no less than 70mm.
The support rod length can be 70mm min. to
285mm max. (If it is more than 285mm, an
extension support rod must be purchased)
3. Fit support rod
If pot filler kit (TF83HJP) has been
purchased, it must be attached to the pre-
rinse unit prior to fitting the support rod
to the riser. Refer to the installation
instruction supplied with the Pot filler.
Screw support rod into the riser hook and
ensure it is not fully tightened.
2. Fit wall bracket
Secure to the wall bracket to the wall.
Supplied fasteners may not be suitable for the
mounting surface. If so, suitable fasteners will need
to be sourced.
Note: The wall flange must be mounted with three
screws for stability and strength. This is critical,
failure to do this may void the warranty.
TF83HJS
4. Fit pre-rinse riser assembly
1. Fit compression nut to support rod, followed by
the compression cone and locate the support
rod into wall bracket.
Fit the pre-rinse riser assembly through the
2.
drilled hole on the bench.
Version 1, 11 July 2017, Page 3 of 5
TF83HJP
Advertisement
