Advertisement
1.1 Site Survey <Step1> : Turn on Site Survey Master CS
・You can set Site Survey Master mode from
Normal mode
1. Insert AC adapter cable to the CS.
(Assume this cell station will be Site
Survey Master Cell Station) .
LED
Green > Amber > OFF > Red flashing
Note:
LED indicates as above explanation when you start site
survey with non-active CS.
Reset button for site survey mode is available even if the
CS has already run in the system. In this case, LED
becomes green generally.
© Panasonic Corporation 2017
normal mode
Fixed IP mode
1. Insert AC adapter cable to the CS
(Assume this cell station will be Site
Survey Master Cell Station)
pressing RESET switch.
2. Release the RESET Switch when the LED
flashes [Green/Red/Amber] alternately,
then the IP address is set to [192.168.0.241]
LED
Green > Amber > OFF > Green/Red/Amber flashing alternately
1. Press RESET switch for 1 second, then the
LED turns on Red and Green flashing alternately.
LED
Red fast flash > Red and Green flashing alternately
[This LED pattern indicates Site Survey master (signal generator) mode.]
2. Put Site Survey Master CS into appropriate
position.
or
fixed IP
mode.
with
7
7
Advertisement
