Advertisement
6.1 PS Registration <Step4> : Confirm the coverage area
1. Start the PS in Maintenance mode.
＊Please see "Section 1.2".
2. Select "PS area check", and then press [OK].
3. Select "On".
4. Press [OK].
5. Press the POWER key until the PS is turned off to exit Maintenance mode.
6. Press the POWER key until the PS is turned on.
7. Repeat the procedure from 1 to 6 for another PS.
1. Call PS(2) from PS(1).（to call the registered phone number by PS Registration.）
You can hear a tone when this signal is received.
2. Set PS(2) close to the CS and move around the service area listening to the
tone from PS(1)'s receiver to confirm voice quality and handover operation.
The CS-ID and signal strength of the CS you are connected to and
the target CS for Handover is displayed on the PS.
When the signal strength is sufficiently strong, the CS-ID is displayed in green.
(Please refer to "41-003" about explanation with visual information.)
© Panasonic Corporation 2017
How to exit PS area check
1. Start the PS in Maintenance mode.
2. Select "PS area check", and then press [OK].
3. Select "Off" and Press [OK].
5. Press the POWER key until the PS is turned off.
6. Press the POWER key until the PS is turned on.
7. Repeat the procedure from 1 to 6 for the other PS.
46
46
Advertisement
