Advertisement
1.1 Site Survey <Step4> : Site Survey by using PS and
Site Survey from
Handset
After Site Survey, you should exit Site Survey Master mode (press RESET button while power is
supplied to CS),
and
© Panasonic Corporation 2017
Confirm CS coverage area
1. Place a CS in the location confirmed for the Air Sync Master CS in
the previous site survey.
2. Supply power to the CS.
3. Start "CS Area Check" mode from Maintenance mode in PS.
＊See "Section 1.2".
In this mode, you will hear a cyclic tone from receiver.
4. Walk around the CS to confirm the CS's service area.
If the radio strength level and Error Rate are at acceptable levels,
you will continue hearing a tone from the PS and 2 lines on the
LCD of the PS light green.
Note : If there is an area where you can't hear a tone and
the 2 lines of the LCD don't light green, relocate the CS.
5. After confirming the service area, press [CANCEL] on the PS
to stop the tone.
6. Relocate the CS to another location.
7. Walk around the CS to confirm the CS's service area.
8. Repeat steps 4 to 7 for all the locations so that the CSs will
provide service for whole area.
9. After finishing CS Area Check, turn off the PS.
(Please refer to "41-003" about explanation with visual information.)
turn off all CS used for Site Survey once.
10
10
Advertisement
